Categories
Contact Us

Cixi Xianghe Communication Equipment Co.,Ltd

Add:Dongfan Industrial Zone, Henghe Town, Cixi, Ningbo City, Zhejiang Province, China

Tel:86-0574-63191191

Mobile:86-15957487368

Fax:86-0574-63191191

Email:sales@xianghetx.com

Heat-Shrinkable Sleeve

Heat-Shrinkable Sleeve use 1, stripping the outer cable. During operation, rotate the sheathed cutter while keeping an eye on the incision, see the white polyester tape, stop feeding and remove the cutter. 2, fixed fiber optic cable and pay attention to core fiber bundle tube. After the optical......

Heat-Shrinkable Sleeve

use

1, stripping the outer cable.

During operation, rotate the sheathed cutter while keeping an eye on the incision, see the white polyester tape, stop feeding and remove the cutter.

2, fixed fiber optic cable and pay attention to core fiber bundle tube.

After the optical cable stripped the outer layer, the optical cable needs to be fixed in the optical cable connector box. Peel the core tube. Do a good job of preparing the optical fiber before welding.

Therefore, it is generally open to the two fixed bayonet appropriate, at this length of the core tube does not cause damage to the optical fiber, but also well fixed. However, when the fixed fiber heat shrinkable tube clamps can not be too tight, otherwise the fiber core tube will be increased due to stress loss, a long time the fiber will break, leaving a hidden danger to the project.

3, optical fiber welding.

The connection of the optical fiber is directly related to the quality and life of the project, and the key lies in the preparation of the optical fiber end face. Fibers have smooth end faces and no burrs or defects. The splicer can accept the splices well and make the splices that meet the requirements of the project. If the end faces of the splices are not acceptable, the splicer refuses to work or the splices that are spliced out are subject to significant loss. Meet the project requirements. Fusion splicer is the key equipment for optical fiber splicing, but also a high degree of precision and expensive equipment. In the course of the operation must be strictly in accordance with procedures to operate, otherwise it may cause heavy losses. Special attention should be paid to the welding machine operating procedures, the length of the optical fiber heat shrink tube set should be consistent with the requirements.

4, Yu fiber protection.

After the optical fiber is welded well, it is necessary to heat-shrink the optical fiber and protect the optical fiber.

A, optical fiber in the optical fiber process, the fiber bending radius can not be too small, generally not less than 4mm. Bending radius is too small, easily lead to excessive refractive index loss and dispersion increases. A long time, there may be broken fiber phenomenon.

B, in the fiber, pay attention to the direction of fiber distortion, the general inverted "8" font, be careful not to break the fiber, the disk after all the optical fiber into the tray under the baffle to avoid damage during packaging fiber.

5, the joint box seal.

In the actual cabling project, the cable splice box seal is very important. Because the optical fiber connector box if water, the fiber shows that it is easy to produce tiny cracks. If the usual time is soaked in water, the fiber will be broken, and cable connector box is buried in the majority. Therefore, the joint box seal is very important.


Hot Tags: heat-shrinkable sleeve, China, manufacturers, suppliers, factory, cheap, buy discount, in stock, made in China
  • Newsletter
  • Categories
  • Contact Us

    Cixi Xianghe Communication Equipment Co.,Ltd

    Add:Dongfan Industrial Zone, Henghe Town, Cixi, Ningbo City, Zhejiang Province, China

    Tel:86-0574-63191191

    Mobile:86-15957487368

    Fax:86-0574-63191191

    Email:sales@xianghetx.com

  • QR Code
  • Copyright © Cixi Xianghe Communication Equipment Co.,Ltd All Rights Reserved.